Please see our other listings if these are also required. If you are running an off-road vehicle with uprated suspension dampers then the likelihood is that you would benefit from the addition of hydraulic bump stops.
As the main damper nears the end of the suspension travel on full compression, a properly installed hydraulic bump stop will absorb and dissipate the harshness of a damper bottoming out - saving not only damage to the main damper but also reduced fatigue on the actual truck (and passengers). By adjusting the oil level, internal shim stack and nitrogen gas pressure the bump stop can be tuned for different track conditions on both the compression and rebound stroke. These units are fully rebuildable and tuneable using off the shelf parts that we carry in stock - spare nylon wear pads, schrader valves, o-rings etc so you can carry out field repairs during a race event. We also offer a 2 travel threaded version which come with an included weld-on mounting can. Please see our other listings for further info. IN STOCK AND AVAILABLE FOR IMMEDIATE DISPATCH! For any technical questions please look us up on Facebook, where one of our experts will be able to offer advice on installation, setup and fine tuning. We both sponsor and run our own top spec offroad trucks in the European Ultra 4 race series using the products that we sell. They are race proven in the harshest environments. This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Steering & Suspension\Shocks, Struts & Assemblies". The seller is "terrafirmafactoryracing" and is located in this country: GB. This item can be shipped to United Kingdom.